Skip to content
ggodart edited this page Jan 1, 2021 · 1 revision

Compool

See original

SYNOPSIS

None

DESCRIPTION

The basic control packet allows the third party controller to

  - Toggle On/Off state of the Spa, Pool, Aux 1 - 7.
  - Enable or disable the Spa side remote(s).
  - Cancel any current circuit delays (not recommended).
  - Change/select heat source/method for Spa or Pool.
  - Change/set desired temperature for Spa and/or Pool.
  - Control Dimmers, (if unit has dimmers installed).
  - Change/set the current time of day in LX3xxx control units clock.

The basic acknowledge packet allows the third party to determine

  - Current state of Spa, Pool, Aux 1 - 7.
  - Current state of Heater and Solar for both Spa and Pool.
  - Whether LX3xxx is in Service mode (no commands should be sent).
  - Current state of Spa side remotes (enabled or not).
  - Current heat source selection.
  - Solar presence.
  - Freeze protection mode.
  - Current water and solar temperature for Spa and Pool.
  - Desired/set temperature for Spa and Pool.
  - Air Temperature (Freeze sensor, not intended offer an accurate )
                    (air temperature                               )
  - Status of temperature sensors.
  - Current time of day stored in LX3xxx unit.

INHERITS

None

METHODS

INI PARAMETERS

Compool_serial_port=COM2

AUTHOR

[email protected] May 16, 2000

SEE ALSO

None

Clone this wiki locally