Add carrier STL that accommodates deeper LED PCBs #20
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Altered inset area of carrier to accommodate taller solder pads on LED board. Rev2 of the LED carrier had PCB sitting too high, causing LEDs to sit proud of the carrier, preventing proper fitment. The inset area has been raised sufficiently to allow the PCB to sit flush.
Darkknight33
changed the title
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Quality control of 3rd party produced PCBs is variable. Some versions are taller than expected and with the supplied carrier do not fit in the Stealthburner front housing. Troubleshooting this unknown fitment issue broke the LED lens, wire connections to the PCB, and the SB front housing. If a deeper carrier had been available, I could have avoided this. So, I edited rev2.
Changes: Altered inset area of carrier to accommodate taller solder pads on LED board. The inset area has been carved out sufficiently to allow the thicker PCB to sit with LEDs flush.