Skip to content

ppicazo/OneWire

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

2 Commits
 
 
 
 
 
 
 
 
 
 

Repository files navigation

OneWire Library

This is just a mirror from Teensyduino

OneWire lets you access 1-wire devices made by Maxim/Dallas, such as temperature sensors and ibutton secure memory. For temperature sensors, the DallasTemperature library can be used in conjunction with this library.

The DS18x20_Temperature has a known bug. Remove "unsigned" from the raw variable on line 88, for correct results below zero degrees Celsius!

Hardware Requirements

OneWire requires a single 4.7K pullup resistor, connected between the pin and +5 volts. Then just connect each 1-wire device to the pin and ground. Some 1-wire devices can also connect to power, or get their power from the signal wire. Please refer to the specifications for the 1-wire devices you are using.

Basic Usage

OneWire myWire(pin);

Create the OneWire object, using a specific pin. Even though you can connect many 1 wire devices to the same pin, if you have a large number, smaller groups each on their own pin can help isolate wiring problems. You can create multiple OneWire objects, one for each pin.

myWire.search(addrArray);

Search for the next device. The addrArray is an 8 byte array. If a device is found, addrArray is filled with the device's address and true is returned. If no more devices are found, false is returned.

myWire.reset_search();

Begin a new search. The next use of search will begin at the first device.

myWire.reset();

Reset the 1-wire bus. Usually this is needed before communicating with any device.

myWire.select(addrArray);

Select a device based on its address. After a reset, this is needed to choose which device you will use, and then all communication will be with that device, until another reset.

myWire.skip();

Skip the device selection. This only works if you have a single device, but you can avoid searching and use this to immediatly access your device.

myWire.write(num);

Write a byte.

myWire.write(num, 1);

Write a byte, and leave power applied to the 1 wire bus.

myWire.read();

Read a byte.

myWire.crc8(dataArray, length);

Compute a CRC check on an array of data.

1-Wire Information

History & Credits

  • Jim Studt wrote OneWire in 2007, originally based on code by Derek Yerger.
  • Tom Pollard added CRC code which eliminated the need for a 256 byte array (in RAM).
  • "RJL20" added the skip function.
  • Robin James rewrote the search function, posting his version here.
  • Paul Stoffregen rewrote the I/O routines for interrupt safety, replaced search with Robin James's code, applied several small optimizations, and started calling it "version 2.0" to distinguish from the many buggy copies online.

About

Arduino OneWire Library (just a mirror of the source code)

Resources

Stars

Watchers

Forks

Packages

No packages published