This mod adds a mount for the BigTreeTech PiTFT. Currently the mod works for the PiTFT70, but im planning on adding a 5" and 3,5" option. The Mount allows the doors to work without any mods and doesnt protude beyond the Skirts. It adds about 11cm to the depth of the printer.
- 1x M3 T-Nut/Hammerhead Nut
- 1x M3x8mm SHCS
- 2x M5 T-Nut/Hammerhead Nut
- 2x M5x10mm BHCS
- 4x M2,5x14mm BHCS OR 4x any M2,5 longer than 6mm
- 1x PiTFT70
- 1x Flat Flexible Cable 50cm or longer for Pi Cam/Pi Display
M2,5x14mm screws are included in the Display, the included Flex Cable is too short.
All Parts are already in the right orientation. Use the standard Voron Specs for printing.
-
Attach the 2 Mounts to the Frame with the M5 screws, feed the Cable through the Slot in the middle Skirt and mount it with the M3 screws.
-
Feed the Cable through the back of the Housing and attach it to the Display (unisolated part faces display). Use the Raspberry Mounts to attach the Display/Housing to the Frame.
-
Simply Push the Front Housing onto the back, it should fit
-
Connect the FFC to the Pis Display port (unisolated part faces towards USB).
-
Install Klipperscreen via KIAUTH or by doing it manually.
-
If the Display is flipped upside down, hit the toggle switch. Adjust the brightness as needed.
Here is a picture of how the FFC should be routed:
