Replies: 3 comments 10 replies
-
It is defined here.
No, not by me since the ESP32 FPU crashes the controller when use in an interrupt context. |
Beta Was this translation helpful? Give feedback.
-
Thanks for quick response, I am going to use the hall sensor, in which it have 3pins (5v, ground and signal). Could you please advise the sensor signal pin connect to either pin B3 or pin A15. |
Beta Was this translation helpful? Give feedback.
-
I learned from one of the grblhal lathe project and copy the photo as below. You said two sensors and 120, are you meaning that the total disc holes is 120 as shown on the photo. |
Beta Was this translation helpful? Give feedback.
-
Hi, I am using the MKS DLC32 controller for my lathe now. I want to use the spindle sync mode but it is not available to select spindle sync mode on the Web Builder. Therefore, I am considering to switch to the blackpill series but I cannot find the rpm counter pin on the stm32F411 board map. Now my spindle driver have the 0-5v pwm and please advise do I need the real time rpm check for the blackpill.
Or, do you consider to add spindle sync mode on the board MKS DLC32 in near future, thanks.
Beta Was this translation helpful? Give feedback.
All reactions