You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I get tis too but only when using the corner homing buttons shown below:
Everything is set correctly and runs fine otherwise (Homes fine with the normal $H Command etc.).
I think I know where the error is though.... seems to be linked to the fact the Y-Axis is reversed on my setup, and the command line generated for these buttons gives a negative direction when it should be positive.
The result being that the soft limits are (correctly) being triggered by the incorrect value.
Put anther way, I think the coding hasn't taken into account the limit switches being on the negative end of the Y-Axis travel.
I have the same problem, but for me the issue only occurs when I try and continuously jog the machine in the y axis. I can single click to move in the y axis and it works just fine. The only time it "locks" up is when I click and hold to jog in the y axis. X and Z axes work both with single click or click and hold.
System locks up when I jog the Y axis. X and Z work fine. Y axis works fine when I run a file. Only problem is when I try to jog the Y axis
The text was updated successfully, but these errors were encountered: