You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Trying to setup zoffset and preheat settings in configuration menu but not saving after power cycle. With SD card in or out.
Bug Timeline
Just set up printer with marlin 2.0.7.1
Expected behavior
Save Z offset for BLTouch probe, and preheat settings when power cycling
Actual behavior
Does not save any changes made to Z offset, or preheat settings (pla/abs) when set to the values I would like/need them to be at to work properly after saving Configuration and power cycling 3d printer.
Steps to Reproduce
Power on printer
Auto home printer
Set zoffset and preheat settings in configuration menu
Save configuration to board
Power off printer
Wait 5-10 seconds
Power on printer
Check if settings saved
Version of Marlin Firmware
2.0.7.1
Printer model
Creality CR-10
Electronics
Big Tree Tech SKR E3 Turbo
Add-ons
BLTouch
Bed Leveling
ABL Bilinear mesh
Your Slicer
Cura
Host Software
SD Card (headless)
Don't forget to include
A ZIP file containing your Configuration.h and Configuration_adv.h.
Will add .zip when I get home to add
Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered:
Kurtis250
changed the title
Z Offset not saving when turns off and back on
Z Offset not saving when power cycling
Jul 1, 2023
2.0.7.1 is old, released Oct 10, 2020 It is no longer getting any maintenance.
Please upgrade your version of Marlin
This Issue Queue is for Marlin bug reports and development-related issues, and we prefer not to handle user-support questions here. (As noted on this page.) For best results getting help with configuration and troubleshooting, please use the following resources:
Did you test the latest
bugfix-2.1.x
code?No, but I will test it now!
Bug Description
Trying to setup zoffset and preheat settings in configuration menu but not saving after power cycle. With SD card in or out.
Bug Timeline
Just set up printer with marlin 2.0.7.1
Expected behavior
Save Z offset for BLTouch probe, and preheat settings when power cycling
Actual behavior
Does not save any changes made to Z offset, or preheat settings (pla/abs) when set to the values I would like/need them to be at to work properly after saving Configuration and power cycling 3d printer.
Steps to Reproduce
Version of Marlin Firmware
2.0.7.1
Printer model
Creality CR-10
Electronics
Big Tree Tech SKR E3 Turbo
Add-ons
BLTouch
Bed Leveling
ABL Bilinear mesh
Your Slicer
Cura
Host Software
SD Card (headless)
Don't forget to include
Configuration.h
andConfiguration_adv.h
.Will add .zip when I get home to add
Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered: